- Bmw E39 Abs Module Installed Without Coding
- Bmw E46 Abs Module Coding
- Bmw E65 Abs Module Coding
- Bmw Abs Module Coding Arduino
Why need recode/code DSC control module?
Have the red brake light yellow DSC and red ABS on the dashboard. Seem to purchase a used module, so the VIN is wrong and does not match the vehicle. Or the module is new and needs programmed and initialized. BMW Scanner V1.4.0 Pa-soft will read coding data, but not able to decode. NCS-expert did.
Tools needed:
ICOM Rheingold engineering software INPA, NCS –expert (and others WinKFP, Ediabas etc)
WIFI BMW ICOM A2 emulator or BMW INPA K+DCAN cable
Code a used DSC module via NCS Expert:
It is a process utilized by BMW, which groups system specific operating requirements (Data) together and then assigns a label/code to each of these groups of data. The various groups of data are all pre-loaded into system specific 'codable' control modules, along with a basic set of operating instructions (Program). Hi there to all. Would like to know how to code a new ABS control module with x431 in a 2000 BMW X5 3.0i. Also this vehicle has 2 conectors 20 (inside the engine bay) and 16 pin (under dahs), which one should be the one for this purposes? Apr 06, 2015 Select 'F4 Process ECU' to code a specific single module. Then the system will display a list of all coding available modules. Select the module you want to code: DSC. NCS-Expert software will display 'DSC get coded' message. Click 'F3 Execute job' button. DSC module coding is completed. DSC indicator light on dash turn off.
BMW model example tested: E39 528iM and BMW E46 325CI. Not sure if it works on other models.
Install DSC module
Select File-> Load Profile
Select Expertmode
Choose F1: VIN/ZCS/FA
Choose F3: ZCS/FA f.ECU
Select Chassis: E39
Bmw E39 Abs Module Installed Without Coding
Install DSC module
Select File-> Load Profile
Select Expertmode
Choose F1: VIN/ZCS/FA
Choose F3: ZCS/FA f.ECU
Select Chassis: E39
Bmw E39 Abs Module Installed Without Coding
Bmw E46 Abs Module Coding
Dean serial number. Choose ECU, OK. NCS Expert is going to read VIN/ZCS/FA information from one of these modules. Choose IKE
Bmw E65 Abs Module Coding
NCS fills in vehicle data.
Choose F3: ZCS/FA f. ECU.
Below 'get coded' seems to be a list of all the modules that can be coded.
Choose F4: Process ECU to code a SINGLE MODULE.
Choose ECU to be coded: DSC
Note 'get coded' now shows only DSC.
(3) files to be used are shown below JOBNAME
Choose F3: Execute Job.
DSC coding completed.
DSC light on dash switched off.
EGS CAN bus speed error was no longer present after checking with INPA software. There were no new codes stored for DSC module.
If necessary, adjust/ initialize/ reset steering angle sensor via INPA software in the end.
Bmw Abs Module Coding Arduino
Who Viewed This Article Also Views:
